Clopay Garage Door EZ_Set Mounting Bracket for Torsion Assemblies

Write a Review
  • Usually Ships Following Business Day

Clopay’s 0122505 EZ-Set Mounting Brackets for overhead garage doors with torsion spring assemblies. These header brackets come in sets of two and are installed on the top corners of garage doors at both ends of the shaft. These garage door parts are designed for straightforward DIY installation on residential doors equipped with Clopay's EZ-Set torsion spring system. They are installed with lag screws to left and right door jambs and with carriage bolts to flange brackets and angle iron. After tension is added to the springs with EZ-Set Winding Units the torsion shaft, spring, and drums are easily installed onto the brackets. One pair of brackets is included in every EZ-Set Torsion Hardware Kit from Action Industries.


  • Essential garage door hardware for torsion assemblies

  • Come in sets of two brackets

  • Holds torsion tube and cable drums

  • Designed for DIY installation on residential doors

  • Works on doors from chamberlain, wayne dalton, genie garage doors, craftsman, and any residential garage door with an EZ-Set torsion system

  • Mounts to door jambs with lag screws

  • Pre-cut with all necessary holes for mounting with fasteners, no additional drilling or cutting required

  • Mounts to jamb bracket and horizontal angle with carriage bolts

  • Made from galvanized heavy duty steel

  • Genuine Clopay replacement part

  • For new garage doors or home improvement on existing garage doors

  • One set of two included in EZ-Set Torsion Kits from Action Industries